Sloped milling using Fabber & VCarve

Hi there, I’m wanting to cut a sloped edge on our Yeti Tool Smartbench. Is is possible to do that using the Sketchup > Fabber > VCarve workflow? I suppose this comes under 3d rather than 2.5d milling.

When I use the Fabber plugin and import into VCarve, I only get a single full depth profile cut. I have the axis setup correctly (I think). Any help much appreciated. Thank you.

Officially no, we can’t do that, however there are some tricks you can do to get those paths in there… Can you attach the file so I can take a look?